Filter
Top Products
There are
10
PRODUCT buttons (0-9) which may be programmed to automatically schedule one, two, three and/or
four stages of cooking with TEMPerature,
TIME,
FAN
and Cooking Curve setting for each stage. (CC is programmed
on the first stage only but is
in
effect for all stages.)
TEMP - Degrees Fahrenheit or Centigrade
TIME - HHMMSS
HH
= Hours MM = Minutes SS = Seconds
FAN
- 0 = Low Speed (during heat cycle), Otherwise
Off
1 = Low Speed Continuous
2 = High Speed Continuous
CC
- 0 - 15 = See Cooking Curve
COOKING CURVE (CC): A relationship between temperature and time. If the oven temperature drops below the
set temperature for any reason, the control will compensate for that loss. The length of time between counts of
the timed countdown will increase to compensate for the temperature loss. The higher the CC number selected
the greater the increase. A cooking curve of
"0"
will not compensate for any change
in
temperature.
SUGGESTED CC
SETIINGS
Baked potatoes
1 to 3
Beef roast
3 to 5
Pies
5
to 8
Bread, cake
6 to 9
Buttermilk biscuits
7 to 9
Muffins
8
to
10
Cookies
9 to
11
Bacon
12
to
13
Generally the more delicate items will require the higher CC settings.
MANAGER SECURITY
The program for each PRODUCT may be operator or manager programmed. A manager programmed product
requires the
4 digit manager code
[0123J
to be entered before entering the program. Manager programmed products
may not be changed or removed without first entering the
4 digit manager code.
SERVICE
'-
If a condition exists which requires a service call, the display will flash SRVICE each time the oven is turned
on
or just before
01\1
is displayed. Diagnosis and display of a problem will not interfere with the operation of the oven
as long
as
the oven is operable. If the display reads OPEN or SHORT, the unit will not operate and an authorized
servicer should be called.
PROGRAMMING MODE
Please read entire instruction before beginning programming mode.
With ON/OFF switch ON
...
DISPLAY DO
1.
ON Press CLEAR ENTER.
2.
ENTER
Within 4 seconds you must press a PRODUCT (0-9). If you
wish to program a manager's PRODUCT, enter the Code
[0123J
prior to a PRODUCT (0-9).
Wait 5 seconds.
-8-