Filter
Top Products
FRONT
OF
DEVICE
•
••
LOCAnNGSTUDS
.0.
'\
. .
BOTTOM
:0:
c:::==::J
:0:
~
REAR
OF
DEVICE
Fig.
1 - Installation of basic
oven
on
cabinet - (procedures identical
for installing open stand, CX286).
Assembling Cabinet Base
or
Stand (PCN903)
1.
Screw two
loceuing
studs (found
in
cabinet base or stand carton) into bottom of oven (Fig.
1).
2.
Mount the oven
on
top of the stand or cabinet (Fig.
1).
I
Assembling
the
Chimney and Flue Extension
Remove the oven chimney and flue extension from the rear of the oven (motor compartment) and use the screws
provided to fasten the chimney to the top rear of the oven. NOTE: The flanges
on
the chimney are to
be
positioned
under the top
cover.
Also attach the flue extension.
Electrical
Connections
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE
PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A
TAG
AT
THE DISCONNECT
SWITCH
TO
INDICATE THAT
YOU
ARE WORKING
ON
THE CIRCUIT.
Assure that the electrical supply agrees with the specifications
on
the oven data plate.
Open the door of the wiring compartment cover by pushing the button
on
the front of the oven (the lower portion
of the control panel). Remove the appropriate knock-out
on
the bottom of the oven and attach the power supply
conduit to the bottom of the oven.
Comply with the appropriate wiring diagram attached to the
oven
when making connections to the electrical supply
lines.
Replace the wiring compartment
cover,
and energize the power supply.
ELECTRICAL
DATA
SINGLE OVEN
I
I,
STACKED OVEN
3 PHASE LOADING
NOMINAL AMPS PER LINE WIRE
TOTAL
(KW
PER PHASE) 3 PHASE 1 PHASE
KW
208-240V
208V. 240V.
208V.
240V.
L1-L2 L2-L3 L1-L3
L1
L2 L3
L1
L2 L3
11
3.35
3.35
4.30
32.0
27.9
32.0
27.7
24.2 27.7 52.8 45.8
22
6.70
6.70 8.60 64.0 55.8 64.0 55.4
48.4
55.4 105.6
91.6
The 208 & 240 volt ovens covered by this manual are for connection to a 1 or 3 phase power system. Ovens leaving the
factory are wired for connection to a 3 phase power system. Wires can be changed at the installation site for connection
to
a 1 phase power system by altering the wiring
at
the terminal block.
Leveling
Adjust the legs to assure that the oven racks are level in the final installed position.
-4-