Filter
Top Products
Ice & Chilled Water
Dispemer
(continued)
If Ice Clumps Form in
Storage Bin...
The Icemaker ejects cubes in
groups of eight, and it is normal for
several cubes to be joined together.
However, if you don’t use the ice
very often, ice clumps may form in
the storage bin and can clog the
dispenser.
If this happens:
●
Remove storage bin from freezer
compartment.
●
Break
up ice
clumps
with
fingertip pressure and discard
remaining clumps.
●
Replace bin before remaining
cubes melt and fuse together.
To Remove Ice Cube
Storage Bin...
Lift the left corner to free the bin
from the shelf, and pull the bin
straight out while supporting it at
front and back.
To Replace Ice Cube
Storage Bin...
Slide the bin back until the
@bon
the bin locks into the slot in the
shelf.
n
Rotate
e~
~
Drive
Mechanism
If bin does not go all the way
back, remove it and rotate the drive
mechanism 1/4 turn. Then push bin
back again until the tab on the bin
locks into the slot in the shelf.
If Ice
h
Not Used Often . . .
Old ice cubes
will
become cloudy
and taste stale. Empty ice storage
bin periodically and wash it in
lukewarm water. Be sure to allow
storage bin to cool before replacing
it—otherwise ice cubes will stick
to the metal auger.
Move
Icemaker
Feeler Arm
to OFF (up)
Wtion
when . . .
●
Home water supply is to be
turned off for several hours.
●
Ice storage bin is to be removed
for a period of time.
●
Going away on vacation, at which
time you should also turn off the
valve
in the water supply line to
your refrigerator.
If This is Your First
Icemaker...
Water Filter
Icemaker
Accessory
-
Your ice cubes can only
be as fresh-tasting as the
water that produces
them. That’s why it’s a
good idea to purify your
water with a water filter.
Its activated charcoal
removes musty,
stale
odors and unpleasant
medicinal, metallic
tastes. A porous fiber
cartridge catches dirt,
rust particles, sand and
silt while special crystals
reduce deposits of hard scale.
The filter is an option at extra
cost, available from your
Hotpoint
dealer. Specify
WRWX214.
It has
complete installation instructions
and installs in minutes on 1/4”
O.D
copper water line.
You’ll hear occasional sounds that
may be unfamiliar. These are
normal
icemaking sounds and are not
cause for concern.
12