Filter
Top Products
Solid
Sbte
Monitor
System
(continued)
The Solid State Monitor System
alerts you when something starts to
go wrong.
If a diagnostic code appears on
the display, something needs
special attention.
To get your
attention, the display code flashes
until you erase it. The first 6
flashes are accompanied by beeps.
If more than one coded function
requires attention at the same
time,
the one with the highest
priority will be displayed first.
Pressing the STATUS CHECK-
RESET pad will evaluate
all
other
coded functions. If the NORMAL
display is lit during the displaying
of a code, that function is operating
properly.
Pressing the STATUS CHECK-
RESET pad will erase three codes
immediately—PE
Cl and
CC.
The DE and FFcodes can only be
erased by touching the STATUS
CHECK-RESET pad
after
the
condition that caused the code to
flash has been corrected.
This flashing code tells you to
check your frozen food. Has any
of it started to
thaw’?
A package
may be holding the freezer
compartment door open. Don’t
open the door more often than
absolutely necessary while this
code is displayed. Touching the
STATUS CHECK-RESET
pad
after the freezer compartment
temperature has returned to
normal
will
erase the code.
This flashing code tells you the
power to the refrigerator has
been interrupted
for more than 2
seconds. Check the condition of
food in both the fresh food and
freezer compartments. Touch
STATUS CHECK-RESET pad
to erase code.
There is no fault with the
refrigerator
when
PF
code
flashes.
This flashing code tells you to
check the automatic icemaker.
Ice
clumps in the storage bin may
have stalled the icemaker. Follow
corrective measures described on
page 12. If water supply to the
icemaker is not connected or not
turned on, make sure manual
icemaker switch is in the
OFF
position (see page 10). Code stops
flashing
when problem is corrected
or STATUS CHECK-RESET pad
is touched.
This flashing code tells you
something’s wrong with the defrost
system—keep doors closed to
retain cold and call for service.
Code flashes until problem is
corrected.
This flashing code tells you to
check temperature controls
and
adjust them if necessary. (See
directions on page 5.) Touch
STATUS CHECK-RESET pad
to erase code. If code reappears
after 4 hours.
call
for service.
8