Filter
Top Products
How to Set the
Door Alarm
You
don’t have to set the visual
alarm. As
long
as
either
door
is
open.
the red DOOR OPEN
signal
light flashes.
If
the green signal light on the
DOOR ALARM pad is glowing,
the beeper alarm is set.
If
it’s not,
touch
the
pad
to turn it
on.
If either
door
is open
for
more
than
30
seconds;,
a
recurring beep sounds.
The light goes out
and
the beeping
stops when you
close
the
door.
There are times when you’ll want
the Door Alarm beeper turned
off. When
you’re
rearranging
a
lot
of
food,
for
example. Just
touch
the
pad. The
green
light will
go
out
and
the beeping will stop.
Deactivating the Door Alarm
beeper does not turn the
red
DOOR
OPEN light
oft-it
keeps flashing
until the door is closed.
Why the Red Warm
Temperature Light G1
OWS
At first, it’s probably because your
newly installed refrigerator hasn’t
completely
cooled
down
yet. Wait
a
few’
hours for it
to
coo],
and
then
the I
ight
will go out.
From then on, the red
light
will
glow whenever temperatures
inside
get
too
high
for
proper
food
stor~.ge.
If this happens, open the doors
only when absolutely necessary,
and
close
them
as
quickly
as
possible.
As soon
as
inside temperatures
return to normal, the I
ight
goes out.
7
How the Solid State
Monitor System
Work
The word NORMAL is lighted
in green except when
a
failure has
been detected.
The STATUS CHECK-RESET pad
has two functions:
1.
You can touch the
STATUS
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
2.
You can touch
the STATUS
CHECK-RESET pad to erase three
flashing codes immediately. Two
codes (DE and
FF)
cannot be erased
until
the condition that caused them
to flash has been corrected (see
page 8).
(continued next page)