Filter
Top Products
13
Reset the alarm signal
• Stop the motor and switch off the lights.
• Press button T3 for at least 3 seconds, until the LEDs
start to flash.
This appliance can be a possible fire hazard if
the grease and charcoal filters are not cleaned
and replaced as recommended.
Changing the halogen spot
lamp
• Remove the lamp from the holder by pulling the lamp
downwards.
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into
the housing on the lamp holder.
• Replace the light cover, fixing it in place with the screws
removed as above.
Replacement filters and light bulbs can be ob-
tained from your local Service Force Centre.