Filter
Top Products
9
Using the cooker hood
The cooker hood is designed to extract unpleasant odours from the kitchen, it
will not extract steam. The appliance can be installed to recirculate or extract
contaminated air.
Cooker hood controls
The hood can be switched on pushing directly onto the requested speed
without firstly having to select 0/1 button.
KEY LED FUNCTIONS
L 0/1 Light Turns lighting on and off.
T1 0/1 Motor on First speed.
When pressed for about 1 second the motor is
switched off.
Flashing 24h Changeover
This is enabled by pressing and holding the button
for approximately 5 seconds. It allows a suction
level of 100 m3/h with a noise level of just 28dB(A).
Can be enabled at any speed, even with the hood
turned off. To disable, press and hold the button for
approximately 5 seconds.
T2 Speed on Second speed.
Flashing Delay (30 minutes)
Press the button for approximately 2 seconds to
enable automatic shutdown with a 30 minutes delay.
Suitable to complete elimination of any residual
smells. Can be enabled at any speed and is disabled
by pressing the button briefly.
T3 Speed on Third speed.
T4 Speed Fixed Max. speed
Flashing Intensive speed.
Suitable for the strongest cooking vapours and
odours. The function becomes active when the
button is pushed for about 2 seconds. After 10
minutes of functioning it turns off automatically.
This function can be interrupted by means of
pressing any of the buttons.
S1 Led Fixed Indicates that the Metal grease filters saturation
alarm has been triggered, and the filters need to be
washed. The alarm is triggered after 100 working
hours. (Reset; check the Maintenance-paragraph)
Flashing Indicates that the activated charcoal odour filter
saturation alarm has been triggered, and the filter
has to be replaced; the metal grease filters must also
be washed. The activated charcoal odour filter is
triggered after 200 working hours. (Activation and
Reset; check the Maintenance-paragraph)