Filter
Top Products
Repair
Base mounted controls
Base mounted controls are located on the base between circulation pumps and
heaters, not behind fascia panels. So:
Dishwashers must be pulled out to change controls.
Dishwashers must be pulled out to measure voltages & resistances.
To access base-mounted controls
Tools needed: T-20 Torx screwdriver & pliers.
1. Remove outer door – see section VA.
2. Remove toe kick – see section VA.
3. Raise (block up) tank – see section VA.
To remove right side panel
Tools needed: T20 Torx screwdriver.
Dishwashers have a short side panel on the right side. Removing it provides
access to the circulation pump and heater and base-mounted control.
1. To remove right side plastic side panels, tilt top of panel and lift out.
Blocking the tank up makes it easier (a screwdriver is needed to remove
base screws first).
To remove base-mounted controls
1. Locate control, open control cover and disconnect wire harnesses from
module after noting connector locations
.
702_58300000149896_ara_en_b
m CAUTION – 75% of all controls returned
for analysis check out OK. Most control
issues are due to loose connections.