Filter
Top Products
Repair
2. Push latch on back of control toward rear of dishwasher, then slide
control from base.
VE. Heaters
The heater, NTC and flow switch can be accessed or measured from the right
side of the dishwasher, but the heater and NTC can only be removed by
removing the base (by flipping the dishwasher upside-down) since the heater
fits tightly underneath the tank.
For access to heaters & NTC’s
Tools needed: Phillips and T-20 Torx screwdriver, pliers.
1. Remove toe kick – see section VA.
2. Flip dishwasher upside-down & remove base – see section VA.
To remove heater, NTC & flow switch
1. Loosen pump - heater hose clamp and remove two T-20 Torx screws
holding heater assembly to sump.
2. Carefully pull heater from sump & pump. The heater comes as an
assembly with housing & gasket.
702_58300000149896_ara_en_b
m CAUTION – 75% of all controls returned
for analysis check out OK. Most control
issues are due to loose connections.