Filter
Top Products
INSTALLATION
If your dishwasher has pre-attached mounting brackets and you have a wooden
under-counter, position brackets as far apart as possible by sliding them within slots in
direction of arrows. Do not attach them to the countertop yet.
If your dishwasher has pre-attached mounting brackets and the counter top is stone,
use pliers to rotate bracket flanges to remove brackets from the top. Grasp brackets
with pliers at perforation and bend until the rounded end breaks free. Discard the
ends. Slip brackets through side slots. Using pliers, bend bracket flanges so the
brackets will not slip through slots. Do not attach them to the countertop yet.
IIC. Electrical connection
Install according to national and local codes.
Carefully place dishwasher on its back to make electrical connections to the terminal
block. Turn power off at the fuse box. Extend power cord approximately 21” from the
left side of the opening, and 30” from the back wall, making sure the cord doesn’t
contact any moving parts.
Strip outer casing of electrical wire to expose 2.5" - 3" (65 - 76 mm) of inner wires,
then strip 1/2" (13 mm) casing from each wire. If plugging the dishwasher into an
outlet, use an approved appliance power cord. Insert cord through a strain relief (not
included) and install to strain relief plate. Attach wires to terminal block (black – L
(hot), white – N (neutral) & green – G (ground). Unscrew terminal screws, but don’t
loosen or remove them as they may become damaged. Attach wires snugly, but don’t
overtighten.
702_58300000149896_ara_en_b