Filter
Top Products
LIGHTS DO NOT WORK
Check if... Then...
The power supply cord is unplugged. Firmly plug the cord into a live outlet with proper voltage.
Light bulb is loose in the socket. Unplug the refrigerator. Gently remove the bulb and reinsert.
Then plug in refrigerator and reset the refrigerator control.
Light bulb has burned out. Replace with an appliance bulb of the same wattage, size and
shape available at your local hardware store. (See the
Changing the Light Bulb(s} section on pages 32-33.) Unplug
the refrigerator prior to replacement.
VIBRATION OR RATTLING NOISE
Check if... Then...
The refrigerator is not resting solidly on Floor is weak or uneven or leveling legs need adjusting.
the floor. See Installation section on pages 9 and 17.
COMPRESSOR MOTOR SEEMS TO RUN TOO MUCH
Check if... Then...
The refrigerator that was replaced was an older
model.
The room temperature is hotter than normal.
The door is opened often or a large amount of food
has just been added.
Modern refrigerators with more storage space require more
operating time. Even though this refrigerator may run more
than your older one it will still use less energy.
The motor will run longer under warm conditions. At normal
room temperatures, expect your motor to run about 40% to
80% of the time. Under warmer conditions, expect it to run
even more often.
Adding food and opening the door warms the refrigerator.
It is normal for the refrigerator to run longer in order to cool the
refrigerator back down. See the Food Storage Guide section
on page 22. In order to conserve energy, try to get everything
you need out of the refrigerator at once, keep food organized
so it is easy to find and close the door as soon as the food is
removed.
The refrigerator was recently plugged in and the The refrigerator will take up to 24 hours to cool completely.
refrigerator control was set correctly.
The refrigerator control is not set correctly for the See the Adjusting Control Settings section on page 21.
surrounding conditions.
The doors are not closed completely. Push the doors firmly shut. Ifthey will not shut all the way, see
Doors will not close completely below.
The back cover is dirty. A dirty back cover prevents air transfer and makes the motor
work harder. Clean the back cover. Refer to the Care and
Cleaning section on page 32-33.
4O