Filter
Top Products
4-10
REMOVING THE DOOR LATCH ASSEMBLY
& THE DOOR SWITCH
1. Unplug range or disconnect power.
2. Pull the range away from the wall so that
you can access the rear of the unit.
3. To remove the door latch assembly:
a) Remove the top and side screws from
the rear panel and loosen the three
bottom screws, then pull the tabs out of
their slots, and remove the panel.
b) Disconnect the 3-wire connector from
the door latch switch terminals.
c) Disconnect the wires from the door
latch solenoid terminals.
d) Remove the two screws from the door
latch assembly and remove it from the
unit.
Rear Panel
2 Screws
Door Latch Assembly
Door Latch Switch
3-Wire Connector
Screw
(1 of 2)
REASSEMBLY NOTE: When you reinstall the
door latch assembly, make sure that the door
latch switch actuator is over the latching rod, as
shown.
Door Latch
Switch Actuator
Latching Rod
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Loosen 3 Screws
Door Latch Solenoid
Terminals