Filter
Top Products
28
17
Removing the Dispenser Assembly
The Dispenser Assembly is located in the lower portion of the dishwasher door below the console
area.
1. Remove the eight (8) screws securing the outer door panel to the dishwasher door frame.
(Fig. 3-7)
Remove the outer door panel from the door frame.
2. Remove the center top hex head screw and remove the dispenser shield and disconnect the
wiring harness connectors from the detergent dispenser solenoid and rinse aid sensor.
(Fig. 3-8)
3. Remove the remaining five (5) screws securing the dispenser assembly to the inner door liner.
(Fig. 3-8)
4. Bend the two locking tabs at the top and bottom of the dispenser assembly up away from the
dispenser body.
5. The dispenser assembly can now be lifted from the inner door liner.
Fig. 3-8
Fig. 3-7
SERVICING COMPONENTS INSIDE THE TUB
Removing the Inner Feed Tube and Lower Spray Arm
The Inner Feed Tube is held in place by two (2) metal clips.
(Fig. 3-9)
One is located on the inner top
of the dishwasher tub. The second is located on the back of the dishwasher tub.
(Fig. 3-10, Inset)
Fig. 3-9
Fig. 3-10
1. Remove the two (2) dishracks from the
dishwasher tub.
2. Unsnap the inner feed tube from the two
(2) metal clips securing it to the dish-
washer tub.
Tab
Tab
Remove This
Screw First
Inset
Clip
Dispenser
Shield
-- NOTES --