Filter
Top Products
24 21
Removing the Wash Motor
1. Remove the bolt securing the wash
motor and drip shield in place on the pump
assembly.
(Fig. 3-20)
2. Once the bolt and drip shield are removed,
turn the wash motor counter-clockwise
until it stops (approximately ¼ turn).
3. Pull the motor straight back from the sump
assembly. Some effort may be necessary
to dislodge the motor. The volute will re-
main attached to the motor. (See Figure
3-24, page 22)
NOTE: When reinstalling the wash motor and
volute, do not pinch the volute seal between the
volute and sump. Use a small amount of rinse
aid on the volute seal to help installation.
(Fig. 3-
24, page 22)
Fig. 3-20
Drip Shield
Inset
Bolt Holds Drip
Shield in Place
-- NOTES --
4. With the wash motor removed, the separation
screen can be removed from the sump base.
(Fig. 3-21)
5. The thermistor can be removed from the sump
by turning it ¼ turn counterclockwise and
pulling it out.
(Fig. 3-22)
The thermistor can
be removed without removing the sump
assembly from the tub. NOTE: Make sure
water is completely drained from sump.
Access to the thermistor can be gained by
removing the access and toe panels while
the unit is in its installed position.
Fig. 3-21
Fig. 3-22
Separation Screen
Thermistor
Chopper Screen