Filter
Top Products
11
Learning Mode
The Learning Mode is ideal for learning how to use the oven.
When set, functions can be entered, with real displays and tones,
without actually turning on the microwave generator (magnetron).
While functions are operating in the Learning Mode, the oven
light will come on, the fan will run, and the turntable will rotate (if
set ON).
While the Learning Mode is active, the Learn indicator is visible in
the upper, right title area, or at the bottom command input area.
The indicator is visible while the oven is in standby mode, during
programming, and during Settings & Info menu navigation.
During a “practice” cooking cycle, the Learn indicator is visible in
the lower, left command input area.
To Activate Learning Mode:
1. On the Main Menu, touch “Settings & Info.”
2. On Settings & Info screen, touch “More Choices.”
3. Touch “Learning Mode.”
4. Touch “On” or “Off” to set.
5. Touch “OK.”
Tones
Tones are audible signals, indicating the following:
One Tone
■ Valid entry (short tone)
Two Tones
■ Between stages (short tones)
■ Reminder (long tones), repeat each minute for 10 minutes
after the end-of-cycle tones
■ End of Timer countdown
■ Hidden feature entered or exited (very short, quick tones)
Three Tones
■ Invalid entry (very short, quick tones)
■ Retry Error
Four Tones
■ End of cycle (2 short tones, followed by 2 longer tones)
■ Interruption, tend to food (short tones)
■ Attention - door needs to be opened and closed
To Adjust Tone Volume:
1. On Main Menu, touch “Settings & Info.”
2. On Settings & Info screen, touch “More Choices.”
3. Touch “Volume.”
4. Using “+” and “-” controls, increase or decrease the volume
setting, or turn the tones off.
5. Touch “OK.”
Start
The START control will start any function.
If non-sensor cooking is interrupted, touching the START control
pad will resume the preset cycle.
For added convenience, the “Start” touch pad is also available on
some display screens, and provides the same function as the
START control pad.
Off
The OFF control stops all functions except for the Timer and
Learning Mode, and cancels programming in progress.
The oven will also turn off when the door is opened. Close the
door and touch START control or “Continue” on the touch screen
to resume the cycle. A sensor cooking cycle may not be resumed
if interrupted by opening the door.
Clear
During programming, the CLEAR control changes the numeric
programming values, such as minutes, seconds and cook power
that are active in the display to their default value. For example,
while entering a cook time, touching CLEAR will change the time
you have already entered to “0:00.” The CLEAR control gives an
invalid signal (see “Tones” section) if touched during cooking.
A. Indicators for Learning Mode
A
A