Filter
Top Products
61
Troubleshooting
PROBLEM
The display is
showing “PF”
A letter followed
by the number
shows on the
display (for
example “E3”,
“F1”)
The display is
showing “F5”
or “E3”
The display is
showing “CF”
POSSIBLE CAUSE
There has been a power
failure.
The power cord is not prop-
erly grounded.
The oven is in the “Convect
full meal” mode.
Reset the clock. (See page 25.)
Press CANCEL/OFF. If the code
does not disappear, call for service.
(See “Requesting Assistance or
Service” on pages 62-63.)
See Installation Instructions.
Refer to section “Using convect full
meal”.
WHAT TO DO
21.)
The key pads
do not operate
Pads not touched long
enough, or not enough time
between each pad pressed.
The Control Lock has been
set.
The Sabbath mode has
been set. (“SAb” appears
on the display.
The range is not properly
grounded.
Hold down the pad a short time, and
allow a short time between each pad
entry.
Turn off the Control Lock by opening
the oven door, pressing and holding
the Control Lock pad (Number Pad
3) for 5 seconds. (See “Using the
control lock” on page
Turn off the Sabbath mode by open-
ing the oven door, waiting up to 15
seconds, and pressing and holding
Number Pad 6 for 5 seconds.
Call an electrician to make sure the
outlet is well grounded. If it is well
grounded, and the key pads still do
not operate, call a service technician.
If none of these items was causing your problem, see “Requesting Assistance or Service” on
page 62, or 63.
9753309A(p41-64)v16(c87) 12/16/98, 8:53 AM61