Filter
Top Products
Fasten the appliance in the
recess - Figure 20
Fasten the appliance in the recess through the
upper and lower hinges of the refrigerator doors.
Use 2 screws for each hinge.
screws
(4 x 16 mm)
Before mounting the door panels
- Figure 21
Remove cover
1
and unscrew the upper
attachment bracket
2
of both refrigerator
doors. These brackets will be mounted onto the
refrigerator door panels.
IMPORTANT
The nuts are needed to fit the premounted
panels onto the refrigerator doors.
Figure 20
Figure 21
Leveling the Appliance - Figure 18
1. Adjust the height
of the appliance at
the front by twisting
the leveling feet
1
(A/F 27). Use the
open-ended spanner
provided.
2. Adjust the height of
the appliance at the
rear by turning the
adjusting bolts
2
.
3. Rotate leveling feet
1
until firmly in
place against the floor.
To prevent the appliance from tipping
forward the leveling feet
1 (Figure 19)
must have contact with the floor.
Figure 18
Adjusting the front of the drawer
- Figure 19
If required, the front of the freezer drawers can be
adjusted.
Transfer the screws shown in the illustration (on the
left and right sides of the freezer drawer) individu-
ally to the long slots below.
Tighten the screws in the front of the drawer once it
is in the right position.
Side view of the freezer
drawer pulled out
Figure 19
12
InstallatIon