Filter
Top Products
Mounting the refrigerator door
panels - Figures 24 - 33
The description is for one panel only. The
procedure is the same for both panels.
1. Open the refrigerator door and hang the panel
on the adjusting bolts (Figure 24).
2. Screw on the hex nuts to the adjusting bolts and
finger tighten temporarily (Figure 24).
Figure 24
Figure 25
3. Close the door and check the height of the
panel.
4. Align the panel in its vertical position if
necessary. Loosen the hex nuts and turn the
adusting bolts using a screwdriver for slotted
screws (Figure 25).
Mounting the freezer drawer
panels - Figure 23
1. Pull out the upper freezer drawer and screw on
the panel with three screws at left and right hand
side using the screws as shown in Figure 23.
2. Close the drawer and check the position to the
surrounding cabinet panels. Align the panel in
vertical direction by loosening the screws left
and right. Finally tighten the screws.
Do not overtighten. Do not use a power
driver.
3. Pull out the lower freezer drawer and fasten the
lower panel in the same way.
4. Finally cover the gap between the drawer and
the panel of both freezer drawers with the strips
provided. Remove the foil from the adhesive
surface of the strip and stick on the top of the
appliance drawer (Figure 23) making sure the
flexible gasket is fully inserted in the gap.
Screw 3.5 x 13 mm
Figure 23
14
InstallatIon