Filter
Top Products
Secure the appliance in place so it does not tip
forward when the fully stocked door is opened.
The
anti tipping bracket is provided with the appliance.
1. Mark the center line of the appliance on the back
wall.
Align the anti tipping bracket center to this
line.
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Drill a 3/8" diameter hole in any position as
shown in Figure 7 using a carbide drill bit.
The depth of the holes must exceed the overall
length of the anchors provided.
Clean the holes after drilling.
3. Attach washer and screw on hex nut to the end
of each anchor.
Drive in all 3 anchors.
Align the bracket center to the center line on the
back wall again.
Fasten the anchors by turning the hex nut.
4. Fasten bracket with 3 screws (1/4" x 2-1/8") into
the wall plate (Figure 8).
Figure 8
Wall Plate
Wall
Mounting the anti tipping device
on wooden floors - Figure 9
1. Mark the center line of the appliance on the back
wall.
Align the anti tipping bracket center to this
line.
Be sure that there is no plumbing or
electrical wiring located in this area which
screws or drills could damage.
2. Fasten bracket to the wooden floor using
5 screws (1/4" x 2-1/8"). Drill pilot holes if neces-
sary.
3. Fasten bracket with 3 screws (1/4" x 2-1/8") into
the wall plate.
Figure 9
Wall Plate
Wall
Mounting the anti tipping device
on concrete floors - Figure 7 - 8
Figure 7
Wall Plate
Wall
8
BlockInG for safety