Filter
Top Products
To make it possible to fasten the refrigerator
panel at the bottom the soft-stop cylinder must be
dismantled.
5. Grasp the soft-stop cylinder and pull down
(Figure 26).
The soft-stop cylinder retracts in the
detached state.
Figure 26
Figure 27
6. Transfer the lower edge of the attachment
bracket onto the panel using a pencil.
(Figure 27). Remove the panel from the
refrigerator door.
Figure 28
7. Dismantle the lower attachment bracket from the
refrigerator door. Align the bracket to the lines on
the refrigerator door panel. (Figure 28).
Fasten the bracket with any hole wherever
possible using a minimum of 6 screws 4 x 16
mm.
8. Open the refrigerator door and hang the panel
on the adjusting bolts (Figure 29).
9. Screw on the hex nuts to the adjusting bolts
and finger tighten temporarily (Figure 29).
Figure 29
15
InstallatIon