Filter
Top Products
Part Number 020001552 5/11 2-1
Section 2
Installation
General
UNPACKING AND INSPECTING
Carefully inspect the refrigeration unit immediately upon
unpacking. Verify the equipment and parts received
against the Bill of Lading. Locate all items according to
packing list and inspect for possible damage caused by
shipping. Notify the appropriate carrier if necessary and
contact MBE immediately for replacement of parts if
discrepancies exist.
1. The Multiplex A&W Model 11 Refrigeration Unit is
pre-assembled in the factory and requires minimum
installation. Locate the following parts supplied with
the unit.
Kit assembly includes:
- Tab clamps for conduit, syrup, and water coils.
- Bracket for drain hose and screws for mounting
- 6 ft (182.9 cm) drain hose
- Six (6) Adapter 1/2” Barb x 1/2” OD Tube
- Twelve (12) Adapter 3/8” Barb x 1/2” OD Stem
- One (1) Adapter 3/8” MPT x 1/2” OD Stem
2. Locate any of the optional Kit Assembly for
mounting to match the type of mounting required.
Install the kit as noted in the instructions supplied.
3. Record the Model Number, Serial Number and date
of installation for future reference, or to be used
when ordering parts.