Filter
Top Products
Installation Section 2
2-4
Part Number 020001552 5/11
Safe Installation Dos and Don’ts
• DO adhere to all National and Local Plumbing and
Electrical Safety Codes.
• DO turn OFF incoming electrical service switches
when servicing, installing, or repairing equipment.
• DO check that all flare fittings are tight. This check
must be performed with a wrench to ensure a quality
seal.
• DO inspect pressure on regulators before starting up
equipment.
• DO protect eyes when working around refrigerants.
• DO use caution when handling metal surface edges
of all equipment.
• DO handle CO
2
cylinders and gauges with care.
Secure cylinders properly against abrasion.
• DO store CO
2
cylinder(s) in well ventilated areas.
• DO NOT exhaust CO
2
gas (example: syrup pump)
into an enclosed area, including all types of walk-in
coolers, cellars, and closets.
• DO NOT throw or drop a CO
2
cylinder. Secure the
cylinder(s) in an upright position with a chain.
• DO NOT connect the CO
2
cylinder(s) directly to the
product container. Doing so will result in an explosion
causing possible death or injury. It is best to connect
the CO
2
cylinder(s) to a regulator(s).
• DO NOT store CO
2
cylinders in temperature above
125°F (51.7°C) near furnaces, radiator or sources of
heat.
• DO NOT release CO
2
gas from old cylinder.
• DO NOT touch refrigeration lines inside units; some
may exceed temperatures of 200°F (93.3°C).
NOTICE: All utility connections and fixtures must be
sized, installed, and maintained in accordance with
Federal, State, and Local codes.
!
Warning
Read the following warnings before beginning an
installation. Failure to do so may result in possible
death or serious injury.