Filter
Top Products
14
Specifications
Rated Flow: .5 gpm (1.9 L)
Min. Op.Temp: 33° F (.6° C)
Max. Op.Temp: 100° F (38° C)
Min. Op. Press: 30 psi (207 Kpa)
Max. Op. Press: 125 psi (862 Kpa)
System tested and certified by NSF
International against NSF/ANSI Std 42 for
the reduction of Chlorine Taste and
Odor,Particulate Class I and against
NSF/ANSI 53 for the reduction of Cysts,
Turbidity,Asbestos, Mercury,Lead,
Benzene, p-Diclorobenzene, Carbofuran
* Based on the use of Cryptosporium parvum oocysts
This system has been tested according to
ANSI/NSF 42 and 53 for reduction of the
substances listed above.The concentra-
tion of the indicated substances in water
entering the system was reduced to a
concentration less than or equal to the
permissible limit for water leaving the
system, as specified in ANSI/NSF 42 and
53.
Specifications
Rated Flow: .5 gpm (1.9 L)
Min. Op.Temp: 33° F (.6° C)
Max. Op.Temp: 100° F (38° C)
Min. Op. Press: 30 psi (207 Kpa)
Max. Op. Press: 125 psi (862 Kpa)
To avoid serious illness or death:
• Do not use refrigerator where
water is unsafe or of unknown
quality without adequate disin-
fection before or after use of
filter.
• Systems certified for cyst reduc-
tion may be used on disinfected
waters that may contain filter
able cysts.
WARNING
After installing a new water filter,
always dispense water for two min-
utes before removing the filter for
any reason. Air trapped in system
may cause water and cartridge to
eject. Use caution when removing.
• The bypass cap does not filter
water. Be sure to have replace-
ment cartridge available when
filter change is required.
• If water filtration system has
been allowed to freeze, replace
filter cartridge.
• If system has not been used for
several months, or water has an
unpleasant taste or odor, flush
system by dispensing water for
two to three minutes. If
unpleasant taste or odor persists,
change filter cartridge.
CAUTION
The PuriClean
®
retractable water filtra-
tion system uses a UKF7003AXX replace-
ment cartridge. Timely replacement of
filter cartridge is essential for perfor-
mance satisfaction from this filtration
system. Please refer to the applicable sec-
tion of your Use and Care Guide for gen-
eral operation, maintenance requirements
and troubleshooting. Suggested retail
price of replacement water filter is
$39.99.
Substance Average Product Avg NSF Reduction Max. Min. % NSF
Reduction Influent Water % Requirements Effluent Red. Test
Red.
Chlorine Taste and Odor 1.9 0.05 97%
> 50%
0.07 96% 508654-02
Particulate 3233333 74667 97.7%
> 85%
260000 92% 508534-02
Class I Particle size: <0.5 to < 1 um
Contaminent Reduction
Cysts* 109000 1 99.99% 99.95% 1 99.99% 508194-02
Turbidity 11.4 0.09 99.1% 0.5 NTU 0.11 99% 508533-02
Lead, pH=6.5 0.15 0.001 mg/L 99.3% 0.01 mg/L 0.001 99.3% 506821-02
Lead, pH=8.5 0.15 0.001 mg/L 99.3% 0.01 mg/L 0.001 99.3% 506822-02
Asbestos 236 0.18 99.92
0.18 x 10
7
0.18 99.92% 508495-02
Benzene 0.015 0.0016 89.6 0.0005 0.005 68.7 508494-02
Carbofuran 0.082 0.001 98.8 0.001 0.001 98.8 508499-02
p-Dichlorobenzene 0.225 0.0005 99.8 0.075 0.0005 99.8 508498-02
Mercury @ pH 8.5 0.0059 0.00035 94.5 0.002 0.001 83.1 508496-02
Mercury @ pH 6.5 0.0059 0.0002 96.6 0.002 0.0002 96.6 508497-02
0.006 mg/L+10%
0.006 mg/L+10%
10
7
to 10
8
fibers/L; fibers
greater than 10 um in length
0.015 mg/L + 10%
0.225 + 10%
0.080 + 10%
Minimum 50,000 /L
11 + 1 NTU
0.15 mg/L + 10%
0.15 mg/L + 10%
Challenge
2.0 mg/L + 10%
At least 10,000 particles/ml
Influent
concentration
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
PERFORMANCE
DATA