Filter
Top Products
22 16023416 ©2004 Maytag Services
Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death:
disconnect electrical and gas supply before servicing.
WARNING!
Moving and/or Replacing Range
1. Turn off electrical power to the range.
2. Slide range forward from installation position.
3. Unplug power cord.
4. Replace range using Installation Instructions.
NOTE: When placing range into installation position,
verify anti-tip bracket(s) are engaged.
Leveling Legs
Some floors are not level. For proper baking, your range
must be level.
• Leveling legs are located on each corner of the base
of the range.
• Place a level horizontally on oven rack and check
front-to-back and side-to-side. Level by turning legs.
Anti-Tip Bracket
When ever range is moved or replaced for safety reasons
this bracket must be engaged.
Anti-Tip Bracket
Leveling Leg
Smoothtop Removal
1. Disconnect power before servicing.
2. Remove screws securing assembly to frame.
NOTE: Open oven door to access screws.
3. Raise smoothtop slightly and move slightly forward.
4. With the smoothtop moved slightly forward, label and
disconnect wire harness.
5. Remove smoothtop and place in a protected area with
underside up.
6. Reverse procedures to reassemble.
Elements
1. Disconnect power before servicing.
2. Remove smoothtop, see "Smoothtop Removal"
procedure. (Perform steps 1 – 5.)
3. Remove screws securing element to assembly.
4. Label and disconnect wiring and remove element.
5. Reverse procedures to reassemble.
Side Panel
NOTE: Removal of range from installation position is
required.
1. Disconnect power before servicing.
2. Remove range from installation position, see "Move
and/or Replacing Range" procedure.
3. Remove smoothtop, see "Smoothtop Removal"
procedure. (Perform steps 1 – 5.)
4. Remove screws securing right side panel at the top
and back of panel.
5. Pull side panel outward away from rear of range, then
lift upward on the side panel to release from slotted
clips located in front and set aside.
6. Reverse procedures to reassemble.
Bake Element
1. Disconnect power before servicing.
2. Remove oven door for easier accessibility, see "Oven
Door(s)-Door Removal" procedure.
3. Remove screws securing bake element to back of
oven cavity.
4. Gently pull element through cavity wall until terminals
can be accessed.
5. Label and disconnect wiring and remove element.
6. Reverse procedures to reassemble.
Broil Element
1. Disconnect power before servicing.
2. Remove oven door for easier accessibility, see "Oven
Door(s)-Door Removal" procedure.
3. Remove broil element support brackets.
4. Remove screws securing broil element to back of
oven cavity.
5. Gently pull element through cavity wall until terminals
can be accessed.
6. Label and disconnect wiring and remove element.
7. Reverse procedures to reassemble.
Oven Sensor
The oven sensor is located inside oven cavity, attached to
the upper left rear wall of the cavity.
1. Disconnect power before servicing.
2. Open oven door and remove screws securing sensor
to oven cavity.
3. Gently pull wiring through cavity wall.
4. Disconnect sensor at connector block and remove.
5. Reverse procedures to reassemble.
NOTE: Verify connector is pushed through the insulation.