Filter
Top Products
©2004 Maytag Services 16023416 23
To avoid risk of electrical shock, personal injury, or death:
disconnect electrical and gas supply before servicing.
Disassembly Procedures
WARNING!
Oven Control/Electronic Clock
1. Disconnect power before servicing.
2. Remove vent deflector by removing screws located on
the underside of the backguard.
3. Remove screws securing backguard panel to
backguard housing. (Screws are located on the
bottom and back side of control panel.)
4. Lift backguard up, tilt forward, and lay panel on a
protected surface of the smoothtop for servicing.
5. Remove screw securing mounting plate to backguard.
6. Disconnect and label wiring and remove oven control/
electronic clock.
7. Reverse procedures to reassemble.
Oven Light Replacement
The oven light used is a 120 volt, 20 watt Halogen bulb.
The light automatically illuminates when the door is
opened, or may be manually activated when the door is
closed via the light pad. The light will not operate during a
clean cycle. The oven light automatically illuminates one
minute before a clock-controlled cooking operation ends.
1. Disconnect power before servicing.
2. Open oven door and locate oven light.
3. Grasp lens cover and pull outward on one side to gain
access to bulb.
4. Carefully remove old bulb by lifting bulb out of ceramic
base.
NOTE: To avoid damaging the new bulb and decreasing
life of the bulb, do not touch new bulb with bare
hands or fingers.
Hold with a cloth or paper towel.
5. Reverse procedures to reassemble.
Lens
Bulb
Socket
Bulb specifications:
G5.3 Type Halogen Bi-Pin 120 volt, 20 watt
Oven Door(s)
Do not place excessive weight on an open oven door or
stand on an opened door as, in some cases, the range
may tip over, break, or cause serious injury.
Both the upper and lower oven doors are removable.
NOTE: DO NOT LIFT OVEN DOOR USING HANDLE.
Damage to the oven door and personal injury
may occur.
Door Removal
• Open door to stop position (approximately 4"), then
grasp both sides of the door and lift up off hinges.
• Lay door on a protected surface, liner side up.
• Close door hinges completely to avoid personal injury.
Door Replacement
1. Open door hinges to first stop position and align slots
on the door with the hinge arms on the range.
2. Slide door downward onto hinge arms until the door is
completely seated on the hinges. Push down on the
top corners of the door to completely seat door on
hinges. Door should not appear crooked.
NOTE: The oven door on a new range may feel “spongy”
when closed. This is normal and will decrease
with use.
Gasket and Door Disassembly
NOTE: Door gasket can be replaced by removing door
insert clips and sliding gasket out of bottom door
insert.
1. Remove oven door, see "Oven Door(s)-Door Removal"
procedure.
2. Remove screws securing doorframe to liner located at
the bottom.
3. Remove side screws securing doorframe to door liner.
4. Remove screws securing door trim at the top.
5. Slide doorframe and glass off liner from the bottom.
6. Remove screws securing door handle to door liner.
(Two on the sides and two in front.)
7. Remove screws securing door baffle to liner.
8. Remove screws securing door baffle to window pack.
9. Remove door baffle and insulation wrap.
10.Remove screws securing window pack to liner.
(Window pack comes out as an assembly.)