4 16023416 ©2004 Maytag Services
WARNING!
Due to the nature of cooking, fires can occur as a
result of overcooking or excessive grease. Although a
fire is unlikely, if one occurs proceed as follows:
Oven Fires
1. Do not open the oven door.
2. Turn all controls to the OFF position.
3. As an added precaution turn off the electricity at
the main circuit breaker or fuse box.
4. Allow the food or grease to burn itself out in the
oven.
If smoke or fire persist call the local fire department.
To avoid risk of property damage or personal injury, do
not obstruct the flow of combustion or ventilation air to
the oven.
To avoid risk of electrical shock, serious personal
injury or death: Verify the oven has been properly
grounded and always disconnect the electrical supply
before servicing this unit.
Safety Practices for Servicer
Safe and satisfactory operation of electrical ranges
depends upon its design and proper installation.
Servicing
Listed below are some general precautions and safety
practices which should be followed in order to protect
the service technician and consumer during service and
after service has been completed.
1. Check range when service is complete—After
servicing, make visual checks on electrical
connection. Inform consumer of the condition of range
before leaving.
2. Adhere to all local regulations and codes when
performing service.
Electrical Requirements
120-volt, 60 Hertz, 15 amp, individual circuit which is
properly grounded, polarized and protected by a circuit
breaker or fuse.
Extension Cord
Due to possible pinching during installation, extension
cords should not be used on products.
Extension cords will adversely affect the performance of
spark system.
Recognize this symbol as a safety precaution.
!
WARNING
!
If the information in this manual is not followed exactly,
a fire or explosion may result causing property
damage, personal injury or death.
There can be a risk of injury or electrical shock while
performing services or repairs. Injury or electrical
shock can be serious or even fatal. Consequently,
extreme caution should be taken when performing
voltage checks on individual components of a product.
The electrical power supply should ALWAYS be
disconnected when servicing a product.
This appliance must be properly grounded. Never plug
in or direct-wire an appliance unless it is properly
grounded and in accordance with all local and national
codes. See "Installation Instructions" that accompany
the product for the appropriate grounding procedures.
GROUND PATH SPECIFICATIONS:
Ground Path Resistance: 0.1 ohms maximum
Insulation Resistance: 250k ohms minimum
WARNING!
To avoid risk of electrical shock, property damage,
personal injury or death; verify wiring is correct, if
components were replaced. Verify proper and complete
operation of unit after servicing.
This appliance contains or produces a chemical or
chemicals which are known to the state of California to
cause cancer, birth defects or other reproductive harm.
To reduce the risk from substances in the fuel or from
fuel combustion, make sure this appliance is installed,
operated, and maintained according to the instructions
in this manual.
Important Safety Information