Filter
Top Products
Before building the appliance in, you
will need to decide on which side the
door is to be hinged. If left hand door
hinging is required, follow the
instructions below.
To change the door hinging you will
need the following tools:
–
a cross-slotted screwdriver,
–
a flat-bladed screwdriver,
–
a selection of Torx screwdrivers,
–
a spanner.
^
Open both appliance doors.
^
Remove covers a, b and c and
caps d with a screwdriver.
^
Slightly loosen fixing screws e at the
top, middle and bottom of the
appliance.
^
Push each of the doors outwards and
take them off their hinges.
^
Unscrew fixing screws e completely,
and loosely screw them in at the top,
middle and bottom on the opposite
side of the appliance.
If you have put locking pins into the
hinges to stop the door opening too far:
^
Remove the locking pins from the top
of the hinges.
To remove the soft-close mechanism
^ Place the doors with the outer side
downwards on a stable surface.
^
Using a screwdriver, carefully push
tension spring a outwards.
Warning. The soft-close mechanism
snaps shut when dismantled.
Danger of injury.
^
Unscrew mounting b and pull
soft-close mechanism c downwards
to remove it.
Changing the door hinging
46