Filter
Top Products
Problem solving guide
66
Water inlet fault
Problem Cause and remedy
One of the following
fault messages appears
in the display:
Open stopcock The stopcock is closed.
Op
en the stopcock fully.
Water intake Before rectifying the problem:
Switch the dishwasher off with the
button.
The water intake is restricted.
Op
en the stopcock fully and start the programme
again.
Clean
the water inlet filter (see "Maintenance").
The wat
er pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
The following message
appears in the display
during the SolarSave pr
o‐
gramme:
Intake temp. low
The intake water has not reached the required tem‐
pe
rature of 45°C (see "Plumbing, Connection to the
water supply").
S
tart the programme again.
If the fault message appears again, select a differ‐
ent pr
ogramme.