Filter
Top Products
Problem solving guide
66
Water inlet fault
Problem Cause and remedy
The In-operation indica‐
t
or is flashing quickly.
The buzzer is sounding.
One of the following
faults is shown in the
display:
Open stopcock The stopcock is closed.
Op
en the stopcock fully.
Water intake Before rectifying the problem:
Switch the dishwasher off with the
button.
The water intake is restricted.
Op
en the stopcock fully and start the programme
again.
Clean
the water inlet filter (see "Maintenance").
The wat
er pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
The following message
appears in the display
during the SolarSave pr
o‐
gramme:
Intake temp. low
The intake water has not reached the required tem‐
pe
rature of 45°C (see "Plumbing, Connection to the
water supply").
Start the programme again.
If the fault message appears again, select a differ‐
ent pr
ogramme.