Miele 9645480 Dishwasher User Manual


 
Plumbing
80
The inlet hose is approx. 1.5 m long.
A 1.5 m long
flexible metal extension
hose, pressure tested to 14000
kPa/140 bar) is available as an op‐
tional accessory, if required.
A stopcock with a 3/4" male thread
must be pr
ovided on site.
This appliance is constructed to
comply with IEC/EN/DIN 61770 //
VDE 0700 Section 600, and may be
con
nected to a suitable supply with‐
out an extra non-return valve if na‐
tional regulations permit.
The water pressure (flow pressure at
the tak
e-off point) must be between
30 and 1000 kPa (0.3 und 10 bar). If
the water pressure is lower than this,
the fault message Water intake will
appear in the display (see "Problem
solving guide"). If the water pressure
is too high, a pressure reducer valve
must be fitted.
After connecting the dishwasher to
the wat
er supply, check that all
plumbing connections are watertight.
T
o avoid any damage to the ap‐
pliance, the dishwasher must only be
connected to a fully vented plumbing
system.
The inlet hose must not be
sh
ortened or damaged in any way as
it contains electrical components
(see illustration).