Filter
Top Products
Problem solving guide
68
General problems
Problem Cause and remedy
The following fault is
shown in the display:
Salt reservoir lid
Dur
ing the programme
the warning buzzer is
also sounding and the
In operation indicator
light is flashing.
The salt reservoir lid has not been closed properly.
C
lose the salt reservoir lid.
If the salt reservoir lid has opened during a pro‐
gr
amme:
Switch the dishwasher off and back on again with
the b
utton.
Close
the salt reservoir lid.
S
tart the programme again.
Detergent residue is left
in the dispenser at the
end
of a programme.
The dispenser was still damp when detergent was
added.
Mak
e sure the dispenser is dry before adding de‐
tergent.
The detergent dispens‐
er lid cannot be closed
pr
operly.
Clogged detergent residue is blocking the catch.
Clean the det
ergent from the catch.
At the end of a pro‐
gr
amme there is a film
of moisture on the in‐
side of the door and the
interior walls.
This is caused by the drying system and does not in‐
dicat
e a fault. The moisture will dissipate after a
while.
Water remains in the
wash cabinet at the end
of a pr
ogramme.
Before rectifying the problem:
Switch the dishwasher off with the butt
on.
The filter combination in the wash cabinet is clogged.
Clean
the filter combination (see "Cleaning and
care, Cleaning the filters").
The drain pump or non-return valve may be blocked.
Clean
the drain pump or the non-return valve (see
"Maintenance").
The drain hose is kinked.
Remove any ki
nk from the drain hose.