Filter
Top Products
Setting Automatic rinsing
To remove any coffee grounds from the
system, the water piping must be
rinsed through before the first drink of
the day is prepared. If Automatic
rinsing is selected, the rinse cycle will
take place automatically whilst the
machine is still cold when the machine
is switched on. This will also pre-heat
the system because hot water is used
for the rinse process. A message will
appear in the display to let you know
what is happening. The machine will
also run an automatic rinse before it
switches off, if it has been used to
prepare a drink.
The machine is delivered with the
Automatic rinsing option set to "On".
To prevent water from
running into the drip tray,
always place an empty cup
under the spout before making the first
drink.
^
Select "Settings F" from the main
menu, and then touch the OK sensor.
^
Touch the right arrow sensor until
"Automatic rinsing" is highlighted and
touch the OK sensor.
^
Touch one of the arrow sensors to
select "On" or "Off" and touch the OK
sensor.
It is a good idea to set this
option to "On" so that the
rinse process cannot be
forgotten.
Setting the Steam system
The machine has two heating systems
which allow you to dispense steam and
coffee at the same time. To save
energy, the steam system can be
switched off if steam is not required all
the time.
When the steam system is
switched off, the machine
can still be used to make
steam, but not at the same time as
making coffee or espresso.
If you operate the steam valve when
the steam system is switched off, the
machine will not produce steam until
it has heated itself up.
The steam heating system remains
active as long as the machine is still
on.
^ Select "Settings F" from the main
menu, and then touch the OK sensor.
^ Touch the right arrow sensor until
"Steam system" is highlighted, and
then touch the OK sensor.
^
Touch one of the arrow sensors to
select "On" or "Off" and touch the OK
sensor.
Settings: Customising your machine
28