Filter
Top Products
3. Setting the buzzer
A buzzer can be set to signal one or
both of the following:
–
End of program = continuous buzzer
–
Error = rhythmic buzz
^
Turn the program selector to "STOP"
f.
^
Turn the machine off.
^
Press and hold "Display" and "Start".
At the same time, turn the lab
washer on with the "On/Off" button.
The displays shows the current
program status "P...".
The "Fill/Drain" indicator illuminates.
^ Press the "Drying" button once.
"E01" appears in the display.
^ Turn the program selector clockwise
to the 10-o’clock position.
The display shows a number
between "100" and "103".
"100" = Buzzer is turned off
"101" = End of program
(factory setting)
"102" = Error
"103" = All functions
(End of program, Error).
^
Press and hold "Display" until the
desired value appears in the display.
^
Press the "Start" button. "SP" appears
in the display.
^
Press the "Start" button again. The
change has been saved.
^
Please note the changed setting:
To turn the buzzer off
^
Turn the program selector to "STOP"
f.
Programming special functions
30