Filter
Top Products
With the aid of the following guide, minor problems can be fixed without a service
call.
What if … Possible fault Fix
the machine does not
start?
The door is not
properly closed.
Close the door firmly.
The fuse is defective
or the breaker has
tripped.
Make sure the circuit breaker
has not tripped.
a few minutes after
starting a program, the
"Fill/Drain" indicator
flashes and the fault
code "F..E" appears in
the display?
–
The water valves
are closed.
–
The filters in the
water inlet hose
are dirty.
– Water pressure is
too low.
–
Turn the program selector to
"Stop" f (the fault code
goes out).
–
Press the "On/Off" button to
turn the machine off.
– Open the water valve or
clean the filters (see
"Machine care").
– Turn the machine on again
and reselect the program.
the wash cycle finishes
too early, the "Fill/Drain"
indicator flashes, and
the fault code "F A"
appears in the display?
– The drain hose is
kinked.
– The drain pump is
blocked.
– Turn the program selector to
"Stop" f (the fault code
goes out).
– Press the "On/Off" button to
turn the machine off.
–
Remove any kinks in the
hose. Clean the drain pump
(see "Machine care").
–
Turn the machine on, run the
drain program then restart
the original program (see
additional program "Drain"
and "Turning on").
Frequently asked questions
35