Filter
Top Products
What if … Possible fault Fix
water in the wash
cabinet is not heated,
the program sequence
lasts too long and a fault
code appears in the
display: "F01 - F02"?
This machine has a
resettable heater limiter
which will switch off the
heater in case of
over-heating. This could
be caused if large articles
cover the heating
elements or if the filters in
the wash cabinet are
blocked.
–
Remove the cause of
the fault.
–
Remove the service
panel (see "Electrical
connection").
–
Press the reset button
on the right side of the
temperature sensor.
If this switch trips
repeatedly, contact the
Miele Technical Service
Department before
further use.
a fault message is
caused by a possible
malfunction?
– Turn the program
selector to "Stop" f
(the fault code goes
out).
– Press the "On/Off"
button to turn the
machine off.
– Turn the machine on
again and reselect the
program.
If the fault code "F..."
appears in the display,
or if you experience
further difficulty, contact
the Miele Technical
Service Department.
Frequently asked questions
36