Filter
Top Products
4. Restoring the factory
settings
^
Turn the program selector to the
"Stop" f position.
^
Turn the machine off.
^
Press and hold "Display" and "Start".
At the same time, turn the machine
on with the "On/Off" button.
The display shows the current
program status "P...".
The "Fill/Drain" indicator lights.
^
Press "Drying" seven times.
"E07" appears in the display.
^ Turn the program selector to any
position (except "Stop").
The display shows either "00" or "PP".
"00"= (factory setting; electronic was
not programmed).
"PP"= (electronic was programmed).
^ If "PP" is displayed, press "Display" to
change from "PP" to "00".
^
Press the "Start" button. "SP" appears
in the display.
^
Press the "Start" button again. Values
which had been changed are now
reset.
If the hardness level setting in the
water softener had been changed,
this will reset to the factory setting of
340 ppm (19 gr/gal). This will need
to be reset to suit the hardness level
in your area.
Programming special functions
31