Filter
Top Products
Before using for the first time
28
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If the function to adjust the Sensor
wash programme has been activated,
the amount of rinse aid dispensed in
the Sensor wash programme can be
higher than that set.
If spots appear on crockery and
glassware:
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
Decrease the rinse aid dosage.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the
button.
Keep the programme selector button
pressed in for at least four
seconds until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button 3 times.
The indicator will flash rapidly 3
times at intervals.
The dosage set will show in the display
after the symbol.
The factory default setting of will
appear in the display.
This indicates a setting of 3 ml.
Use the programme selector button
to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The setting is now stored in memory.
Switch the dishwasher off with the
button.