Filter
Top Products
Problem solving guide
71
General problems
Problem Cause and remedy
Detergent residue is left
in the dispenser at the
end of a programme.
The dispenser was still damp when detergent was
added.
Make sure the dispenser is dry before adding
detergent.
The detergent
dispenser lid cannot be
closed properly.
Clogged detergent residue is blocking the catch.
Clean the detergent from the catch.
At the end of a
programme there is a
film of moisture on the
inside of the door and
the interior walls.
This is caused by the drying system and does not
indicate a fault. The moisture will dissipate after a
while.
Water remains in the
wash cabinet at the end
of a programme.
Before rectifying the problem:
Switch the dishwasher off with the button.
The filter combination in the wash cabinet is clogged.
Clean the filter combination (see "Cleaning and
care, Cleaning the filters").
The drain pump or non-return valve may be blocked.
Clean the drain pump or the non-return valve (see
"Maintenance").
The drain hose is kinked.
Remove any kink from the drain hose.