Filter
Top Products
Programme options
53
Buzzer tones
A sequence of audible tones will sound
at the end of the programme or if there
is a fault.
The buzzer at the end of a programme
and warning tones in the event of a
fault sound 4 times at intervals with a
short pause between each set of tones.
The buzzer tones are set to off ex-
works.
If you want the buzzer to sound at the
end of a programme you will have to
set it. Buzzer tones for faults are always
active.
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the
button.
Keep the programme selector button
pressed in for at least four
seconds until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button 4 times.
The indicator will flash rapidly 3
times at intervals.
The flashing sequence in the display
shows whether the buzzer at the end of
the programme is activated or
deactivated.
– : Buzzer tones switched on
– : Buzzer tones switched off
Press the programme selector button
if you wish to change the setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.