Filter
Top Products
Problem solving guide
69
Water inlet fault
Problem Cause and remedy
The In-operation
indicator is flashing
quickly.
The buzzer is sounding.
The Inlet/Drain
indicator is flashing on
and off.
The stopcock is closed.
Open the stopcock fully.
The In-operation
indicator is flashing
quickly.
The buzzer is sounding.
The Inlet/Drain
indicator is flashing and
fault code or has
appeared in the display.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.