Filter
Top Products
The temperature being set will flash in
the display.
The following information shows in the
display when the sensors are touched:
–
Touching a sensor once: the last
temperature selected flashes.
–
Each subsequent touch of a sensor:
adjusts the temperature shown in
1 °C steps.
–
Leaving a finger on the sensor:
changes the temperature
continuously.
When the highest or lowest
temperature in the range is reached,
the X or Y sensor disappears.
Approx. 5 seconds after taking your
finger off a sensor, the average,
current temperature of the freezer is
automatically shown.
If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very full and for
approx. 24 hours if the appliance is
full before checking the temperature
display, as it will take this long for the
display to give an accurate reading. If,
after this time, the temperature is still
too high or too low, you will need to
adjust it again.
Temperature range
The temperature in the freezer section
can be adjusted from -14 °C to -28 °C
The ambient temperature in the room
and the installation location can affect
the time it takes for the appliance to
reach the lowest temperature. If the
ambient temperature is too high, the
appliance may not reach the lowest
temperature.
Temperature display
During normal operation the
temperature displays on the control
panel show the temperature in the
middle of the PerfectFresh zone and
the temperature in the warmest part of
the freezer section.
Changing the temperature display
brightness
The temperature display brightness can
be adjusted to suit the lighting
conditions of the room.
^ Touch and leave your finger on the X
sensor.
^
At the same time, briefly touch the
On/Off sensor (without letting go of
the X sensor).
^
Leave your finger on the X sensor for
another 5 seconds until c appears in
the display.
^
Touch the X sensor repeatedly until
d appears in the display.
^
Touch the On/Off sensor.
The correct temperature
21