Filter
Top Products
Caution. The upper door is not
secure as soon as the upper hinge
plate is removed.
^
Close the upper door.
^
Undo screws m in upper hinge plate
n and pull it upwards and off.
^
Carefully lift the upper door off and
place it to one side.
^
Make sure that you leave the hinge
pin in the hinge plate in the middle of
the appliance, as otherwise the lower
door will be unsecured.
^ Then fit cover h together with
retainer i on the opposite side.
^ Refit cover l on the opposite side.
Removing the lower soft-close door
mechanism
^ Open the lower door.
^
Remove panel a from the soft-close
mechanism by inserting a flat-bladed
screwdriver into the gap from above
and easing it off bit by bit.
Take care not to damage the door
seal.
If the door seal is damaged, the
door will not close properly and
cooling will be impaired.
^ Slide panel a towards the appliance,
and leave it hanging between the
door and the appliance.
^ Fit restraining clip b (supplied with
the appliance) onto soft-close
mechanism c.
The restraining clip stops the hinge
from snapping shut. Do not remove the
clip until told to do so.
^
Carefully remove cover d from the
side using a flat-bladed screwdriver.
^
With the help of another person, tip
the appliance back slightly.
Changing the door hinging
69