Filter
Top Products
10 11
Electrical circuit diagram
5-point gas re-ignitor
120 Vac/60 Hz/3 VA
spark/sense
re-ignition
earth
N
A
SW1
SW2
SW3
SW4
SW5
S1
S2
S3
S4
S5
120V/60HZ
main connecting board
L
N
TWO ZONE
WOK BURNER
12-leds
com
S1
LED
com
S1
LED
9-leds
com
S1
LED
9-leds
9-leds
com
S1
LED
com
S1
LED
9-leds
FRONT RIGHT
BACK RIGHT
BACK LEFT
FRONTLEFT
Problem
Burner does not burn well
Ignition sparks but burner
does not ignite
Ignition does not spark
Cause
– Burner dirty or moist
– Not suitable for type of gas
– Burner dirty or moist
– Burner cap not aligned
properly
– The appliance has not yet
been plugged in properly
– Ignition is defective
Solution
– Clean and/or dry the burner
– Check identification plate
and if necessary have the
appliance adapted
– Clean and/or dry the burner
– Position the cap properly
onto the ring
– Plug in the appliance
properly
– Phone the Miele Service
Department
If your appliance does not operate as desired,
first check if you can solve the problem yourself
by using the table above. There is often a simple
reason for the problem.
Repairs to the gas and electrical components of
this appliance must only be carried out by a
suitably qualified person (licensed gas fitter in
Canada).
Repairs by unauthorised personnel could be
dangerous and are not covered by the
guarantee.
In the event of any fault on this appliance,
please contact:
– your Miele dealer or
– the Miele Service Department,
the address of which is shown on the back
page.
Please quote the model and serial number of
your appliance. You will find both on the data
plate located on the underside of the appliance.
Troubleshooting