Filter
Top Products
12 13
Warning
As shown in the above diagram, the regulator
included must be used when connecting the
Miele hob.
– Any pipe connections must be made using a
thread sealant approved for gas connections.
Failure to correctly install these items could
lead to a gas leak and subsequent explosion.
– Do not use any regulator unless it has been
supplied by Miele Appliances.
Connect the gas supply to the pressure
regulator using a 1/2” gas line connector
between the shut-off valve and the pressure
regulator. Flexible harmonica-type stainless
steel pipe is recommended.
For USA only
The gas connection must be made in
accordance with the local codes, or in absence
of local codes, with the National Fuel Gas Code
ANSI Z 223.1.
Gas pressures for USA
Natural gas
Max. supply pressure: 1/2 psi
Min. supply pressure: 5˝ water column
Liquid propane gas, after converting this
appliance with conversion kit number AH102 C4U.
Max. supply pressure: 1/2 psi
Min. supply pressure: 11˝ water column
Manifold pressure:
– natural gas 4˝ water column
– propane gas 10˝ water column
Gas connection
These appliances must be installed with a
separate shut-off valve and a gas pressure
regulator.
Both shut-off valve and pressure regulator must
be easily accessible to the consumer.
The shut-off valve is solely intended to be used
to shut off the gas supply.
This appliance and its individual shut-off valve
must be disconnected from the gas supply
piping system during any pressure testing of that
system.
The hob comes equipped for natural gas.
You should find out details about the type of gas
and calorific value from your Gas Utility and
compare this information with the type of gas
quoted on the data plate.
Before using the appliance, check the
connection with a soapy solution for leaks.
Never use a flame of any sort. The interior of
this appliance has been tested by the
manufacturer.
Pressure regulator
A pressure regulator is included with the
appliance.
After installing a gas shut-off valve in an easily
accessible location under the hob, install the
gas pressure regulator to the manifold pipe
using pipe dope on threads of the manifold pipe
(see also next page).
Electrical connection
The automatic ignition and the safety device
require connect ion to an A.C. single phase
120 V, 60 Hz supply. Fuse rating 6 A.
The appliances are factory equipped with a
power supply cord with molded three prong plug
– ready for connection to an electrically
grounded socket which complies with your local
electrical codes or with the National Electrical
Code ANSI/NFPA No. 70 for the USA or
Electrical Code Part I for Canada.
Ensure that the receptacle is positioned so that
it is easily accessible when the appliance is
built in.
Check that the data given on the data plate
under the appliance complies with the mains
voltage.
Warning:
This appliance must be grounded.
Do not cut or remove the grounding prong from
the plug.