Filter
Top Products
2322
1. First loosen the 8 mm ring securing the gas
feed pipe. Disconnect the gas pipe. The
actual injector is a thin metal cap mounted
between the two brass fittings attached to
the left of the wok burner body.
Inner ring injector
2. Two 12 mm wrenches are needed to
separate the fittings.
Use one 12 mm wrench to keep the right-
hand fitting in place, while using the other
12 mm wrench to loosen the left-hand fitting.
3. With the left fitting loosened, unscrew the
right-hand fitting from the wok burner body.
4. Holding them vertical, take both fittings
apart. The metal cap with the injector will
remain on top of the lower fitting. Replace
the injector cap with the injector cap marked
007 (034, natural gas) and put the two fittings
back together.
Warning
Make sure that the natural gas injector is
removed from the fitting when the propane gas
injector is installed.
5. Screw the assembled fittings back into the
wok burner body. Carefully tighten both
fittings. Do not overtighten.
6. Reattach the gas pipe and tighten the 8 mm
ring.
Note
Inner ring air slot (A)
Adjust the air slot on the inner ring injector now.
The slot is adjusted by shifting the metal clip
around the right-hand fitting. Move the clip to
obtain a full opening of the hole (A) in the fitting.
Reference table
gaspipe
injector
A
B
Wok burner outer ring conversion
Outer ring injector (B)
The wok burner outer ring injector is located on
the right hand side of the wok burner body (B).
1. Unscrew the screw holding the brass tube to
the left of the injector. Access this screw
from the rear. Slide the brass tube to the left,
but do not insert it into the aluminium tube all
the way.
2. Use a 10 mm wrench and unscrew the outer
ring injector. Support the aluminium gas pipe
feeding the injector by holding it down, while
turning the wrench. Unscrew the injector
and replace it with the injector marked 090
(170, natural gas).
Note
Outer ring airslot (B)
Adjust the air slot on the outer ring injector now.
The correct distance for the air slot (B) is 0.083".
Slide the brass tube to the prescribed distance
and tighten the holding screw at the rear of the
tube.
Wok burner inner ring conversion
Inner ring injector (A)
The inner ring injector is located on the left
hand side of the wok burner body (A).
A
B
A
B
A
B
LP gas
adjustment
injector screw
high-speed burner 0.75 mm 0.36 mm
0.03” 0.014”
super high-speed burner 0.87 mm 0.40 mm
0.034” 0.016”
wok burner inner ring 0.50 mm 0.25 mm
0.02” 0.01”
wok burner outer ring 0.90 mm 0.54 mm
0.035” 0.021”
natural gas
adjustment
injector screw
high-speed burner 1.45 mm 0.55 mm
super high-speed burner 1.66 mm 0.60 mm
wok burner inner ring 0.60 mm 0.42 mm
wok burner outer ring 1.70 mm 1.00 mm