Filter
Top Products
Repairs may only be carried out by
a suitably qualified and competent
person in accordance with national
and local safety regulations. Repairs
and other work by unqualified
persons could be dangerous. The
manufacturer cannot be held liable
for unauthorised work.
Some minor problems can be corrected
without contacting Miele.
Please note: A call-out charge will be
applied to unnecessary service visits
where the problem could have been
rectified as described in these
operating instructions.
What to do if...
...aprogramme will not start.
Check whether,
^ the appliance door is closed
properly.
^
the system lock has been activated
(see "System lock").
^
"door" appears in the display. The
door has not been opened for a long
time (approx. 20 minutes). See "door"
message.
^
the appliance is plugged into the
mains supply and switched on at the
socket.
^
the mains fuse has tripped because
the mains voltage or another
appliance is faulty (disconnect the
appliance from the mains supply and
call a qualified electrician or Miele.
See "After sales service".).
. . . a noise can be heard after a
cooking programme.
This is not a fault.
The cooling fan will continue to run for a
while after the oven has been switched
off to prevent any humidity building up
in the oven, on the control panel or on
the oven housing unit.
It will switch off automatically.
. . . the display does not light up.
Check whether,
^
the time of day display has been
switched off (press and hold the m
button for a few seconds).
^ the time of day display has been
programmed to switch off at night.
. . . the turntable does not turn
smoothly.
^ Check whether the area underneath
the roller ring is clean.
^
Check whether the surfaces between
the turntable and the carrier are
clean.
Remove any soiling.
. . . food is not adequately defrosted,
heated or cooked at the end of the
selected cooking duration.
^
Check whether the correct power
level was selected for the duration
set.
The lower the power level, the longer
the duration required.
^
Check whether the programme has
been interrupted and not restarted.
Problem solving guide
42