~
Do not use the microwave if
– the door is warped.
– the door hinges are loose.
– holes or cracks are visible in the
casing, the door or the oven interior
walls.
Operating the appliance with this type
of damage will result in microwave
leakage and present a hazard to the
user. Clean the inside of the oven and
all the accessories with warm water
applied with a well wrung-out soft
sponge or cloth.
~
Never open the casing of the
appliance.
Tampering with electrical connections
or components and mechanical parts is
highly dangerous and can cause
operational faults or electric shock.
~
Before connecting the appliance,
make sure that the connection data on
the data plate (voltage and rated load)
match the mains electricity supply. This
data must correspond in order to avoid
the risk of damage to the appliance.
Consult a qualified electrician if in
doubt.
~
Do not connect the appliance to the
mains electricity supply by a
multi-socket unit or an extension lead.
These do not guarantee the required
safety of the appliance (e.g. danger of
overheating).
~
The electrical safety of this
appliance can only be guaranteed
when continuity is complete between it
and an effective earthing system which
complies with local and national safety
regulations. It is most important that this
basic safety requirement is present and
tested regularly and, where there is any
doubt, the household wiring system
should be inspected by a qualified
electrician.
The manufacturer cannot be held liable
for the consequences of an inadequate
earthing system (e.g. electric shock).
~
For safety reasons, this appliance
may only be used when it has been
fully installed.
~
Repairs may only be carried out by
a suitably qualified and competent
person in accordance with national and
local safety regulations. Repairs and
other work by unqualified persons
could be dangerous. The manufacturer
cannot be held liable for unauthorised
work.
~
While the appliance is under
warranty, repairs should only be
undertaken by a service technician
authorised by the manufacturer.
Otherwise the warranty will be
invalidated.
~
The appliance is only completely
isolated from the electricity supply
when:
– it is switched off at the wall socket
and the plug removed.
– the mains fuse is disconnected,
– or the screw-out fuse is removed (in
countries where this is applicable).
~
Faulty components must only be
replaced by genuine Miele original
spare parts. The manufacturer can only
guarantee the safety of the appliance
when Miele replacement parts are
used.
Warning and safety instructions
8