Filter
Top Products
39
OPERATING PROCEDURE
8. Compressor cover ➔ machine chamber fan motor
(1)Remove 7 screws for compressor cover at the back of the refrigerator.
Machine chamber fan motor
(2)Remove screw one fizing screw of bellmouth and connector. Then pull out the bellmouth.
(3)Pull out the fan from the fan motor.
(4)Remove one lid-fixing screws to take out the fan motor.
: This mark shows welded point.
w
w
w
w
w
w
w
w
w
w
w
w
Compressor
Heat radiation
pipe of flat face
flange
Heat radiation
pipe of left side
Machine chamber
fan motor
Charge pipe
(Low pressor side)
Charge pipe
(High pressor side)
Dryer
Three-way valve
Keep the clearance
between each parts
for 10 to 15mm
WW
Heat radiation
pipe at back side
Heat radiation
pipe at right side
W
Bell mouth
Figure 7
Attach U washer as the figure shown below.
W Note 1: Form the pipe so that it can be slanted toward the upper right. (Approx. 15 degrees).
Piping connection of three-way valve
Exit
(right)
[1.6✕[0.63
Exit
(left)
[1.8✕[0.67
To capillary tube
To capillary tube
OA090-2.qxp 06.7.20 9:57 AM Page 39