Filter
Top Products
MultiModem rCell User Guide 34
Chapter 3 - Using the WEB Management
Software
This chapter describes how to configure the router by using the Web Management software.
Software Interface Overview
This section explains the menu structure and the navigation buttons of the router’s Web Management software.
Menu Bar Overview
You can select the following items from the menu bar:
IP Setup
Sets up a General Configuration, HTTP, DDNS, SNTP, Static Routes, and Remote
Configuration.
PPP
Used to configure the PPP authentication, dial-on-demand, router authentication, and
Wakeup on Call.
Networks & Services
Used to configure networks and services to make them available to other functions such as
allowed packet filters, static routes, remote configuration, DNAT, and GRE tunnels and
routes.
Packet Filters
Defines filter rules, DNAT configuration, and ICMP rules.
GRE Tunnels
Used to define Generic Routing Encapsulation (GRE). Defines the remote network and the
tunnel through which traffic is routed.
DHCP Server
Used to configure the DHCP server settings.
IPSec
Allows the device to support LAN-to-LAN VPN tunneling with 3DES and AES 128-192-256
encryption support
Serial Port
Adds support for RS-232 serial port so that Ethernet and legacy serial devices can share the
same cellular connection.
Tools
Sets DDNS Force Update, displays DDNS Status, resets the modem, and provides interfaces
for Firmware Upgrade, Load Configuration, and Save Configuration.
Statistics & Logs
Shows statistics and logs maintained by the router.
Save & Restart
Saves your settings and reboots your router.
Help Index
Opens the online Help file.
Submitting, Saving and Restarting Overview
Nearly every page of the software’s interface includes a Submit button. This button allows you to save changes
you make to the software pages and their parameters.
To ensure your changes go into effect, you must eventually use Save & Restart, located on the Menu bar. You do
not need to click Save& Restart after each change you make. You can change several areas, and then click Save &
Restart.