Filter
Top Products
Chapter 3 – Using the Web Management Software
44 MultiModem rCell User Guide
Daylight Configuration Group
Daylight Saving Enable or disable Daylight Saving mode. The default is Enable.
Daylight Saving
Offset
Set the offset to use during Daylight Saving mode. Default is +60 minutes. Enter the time in + /
- minutes
.
Daylight Saving Start Time Group
Start Ordinal Set the start ordinal to use during Daylight Saving mode. Options are first, second, third, fourth
and last. Default is second. Daylight Saving time usually starts at the same time on the same day
of the week in the same month every year. Each day of the week occurs four or five times a
month. Therefore, select the week in which daylight saving time starts, either the first, second,
third, fourth or the last of the month.
Start Month Set the start month to use during Daylight Saving mode. Default is March.
Start Day Set the start weekday to use during Daylight Saving mode. Default is Sunday.
Start Time Set the start time to use during Daylight Saving mode. Default is 02:00 (hh:mm).
Daylight Saving End Time Group
End Ordinal Set the end ordinal to use during Daylight Saving mode. Select the week in which daylight saving
time ends. Options are first, second, third, fourth and last. Default is first.
End Month Set the end month to use during Daylight Saving mode. Default is November.
End Day Set the end weekday to use during Daylight Saving mode. Default is Sunday.
End Time Set the end time to use during Daylight Saving mode. Default is 02:00 (hh:mm).
Submitting and Saving Your Changes
To save your changes, click Submit.
To ensure your changes go into effect, click Save and Restart.
IP Setup, Static Routes Parameters
Networked computers use routing information to identify whether they are sending data packets directly to the
firewall or to another network.
After you define and add a route, you can use the table at the bottom of the group to delete or edit the route.